forklift manufacturers in chinacustom summaryhydraulic platform liftfrequent problems

 

The hydraulic platform lift customized by forklift manufacturers in china has to undergo formal inspection and debugging before leaving the factory, and can only be put on the market when various technical indicators meet the standards. Connect the power supply when in use, the hydraulic, electrical and other systems do not need to be adjusted, and are placed on a solid and flat ground during use to avoid tipping. This is just one of the problems, the specific problem, forklift manufacturers in china customized to analyze with you a wave.

If the workbench does not work, stop it immediately for inspection; when the working pressure of the electric lift is too high or produce abnormal sound, immediately shut down and check to avoid more serious damage to the machine; check the shaft pin regularly every month, if the shaft pin or screw is found to be loose Take off, forklift manufacturers in china custom remind everyone to lock the hydraulic platform lift in time to prevent the shaft pin from falling off, causing personal injury and property damage. The hydraulic oil should be kept clean and replaced every six months; the safety prop must be supported during maintenance and cleaning of the lift.

Next, forklift manufacturers in china will discuss some common problems in detail. I hope you will remember them carefully, because they may be used in the future use of equipment:

Lifting or lifting force is a very troublesome thing. This may be because the pressure adjustment of the relief valve does not meet the requirements, and it can be adjusted to the standard pressure value; it may also be because the oil cylinder leaks, and we need to check the components at this time. Forklift manufacturers in china prompts to replace the oil cylinder if necessary; Hydraulic platform lift means that the reversing valve is clamped or leaked, and the valve assembly can be replaced. If the oil level is too low and the oil inlet filter is blocked, then the oil filter needs to be cleaned.

When the lift table is maintained, the staff must hang the lift when entering the lift table to prevent the lift table from falling suddenly and causing danger. Check the rollers, intermediate shafts, bearings, cylinder pins, bearings and other components once a month, as well as the lubricity and wear of the boom hinge shaft and bearings; also check the hydraulic oil quality and oil level. When the lift table is raised, the hydraulic oil level should be 40-50mm higher than the bottom of the oil tank. When the oil color of the hydraulic oil becomes dark, the oil is sticky, and there is grit in the oil, forklift manufacturers in china custom remind everyone to replace it in time Hydraulic oil.

Forklift manufacturers in china custom suggest to check hydraulic platform lift hydraulic and piping connection parts once a year. If the pipe is damaged, replace it immediately, and tighten the pipe joint when the connection part is loose. Remove and disassemble the lowering valve, blow the valve core with compressed air and re-install it. Drain the hydraulic oil in the oil tank, open the oil tank and take out the oil suction filter, clean it and install it in its original position, and then fill it with new oil.